Applied Motion STM17C-3CE - Manual

STM17C Quick Setup Guide
Requirements
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7.
▪ ST Configurator™ software (available at www.applied-motion.com).
▪ An RS-232 Applied Motion programming cable (included).
▪ A 5 pin spring connector (included) for connecting to the CAN network
▪ For more detailed information, please download and read the STM17 Hard-
ware Manual available at www.applied-motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 1 - Power Supply and I/O Wiring
▪ Wire the drive to the DC power source.
Do not apply power until Step 3.
Note - the STM17 accepts DC voltages from 12-48V. If using an external fuse,
we recommend: a 3AG, 2 Amp Slow Blow (Littelfuse 313002.HXP).
See the STM17 Hardware Manual for more information about power supply and
fuse selection.
▪ Connect I/O, if required by your application.
See the STM17 Hardware Manual for more information about connecting I/O.
I/O CONNECTIONS CANOpen
RS232
POWER
CONNECTIONS
▪ Connect the RS-232 programming cable.
▪ Download and install ST Configurator™ soft-
ware, available at www.applied-motion.com.
▪ Launch the software by clicking Start/Programs/Ap-
plied Motion Products/ST Configurator
▪ If you have any questions or comments, please call Applied Motion Products
Customer Support (800)525-1609 or visit us online www.applied-motion.com.
Step 2 - ST Configurator
920-0045 A
If you have any questions or comments, please call Applied Motion Products Customer Support:
(800) 525-1609, or visit us online at www.applied-motion.com.