Applied Motion ST10-Plus - Manual

Serial No
Error Codes
GR-Green RD-RED
DRIVE OVER TEMP
1 GR + 3 RD
VO LTAGE HIGH
1 GR + 4 RD
VO LTAGE LOW
2 GR + 4 RD
OVER CURRENT
1 GR + 5 RD
COMM ERRO
R
1 GR + 7 RD
ST5-S
GND
B-
B+
A- A+
V-
V+
AN 1
+5 V
OU T+
OU T-
EN-
EN +
DIR -
DIR +
STE
P-
STE
P+
ST5/10-Plus Quick Setup Guide
Requirements
▪ A compatible stepper motor.
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A personal computer running Microsoft Windows 95, 98, NT, Me, 2000 or XP, Vista or 7.
▪ ST Configurator™ software (available at www.applied-motion.com).
▪ An Applied Motion programming cable (included).
▪ For more detailed information, please download and read the ST5/10-S Hard-
ware Manual, available at www.applied-motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 1
a) Download and install the ST Configurator™ software.
b) Launch the software by clicking:
Start / Programs / Applied Motion Products / ST Configurator
c) Connect the drive to your PC using the appropriate programming cable.
Step 2
a) Wire the drive to the DC power source.
(do not apply power until all connections to the drive have been made)
Note, the ST5-Plus accepts DC voltages from 24-48V, while the ST10-Plus accepts
DC voltages from 24-80V.
b) Ensure a proper earth ground connection by using the screw on the left
side of the chassis.
If using an external fuse, we recommend the following:
ST5 : 3AG, 4 amp (Littlefuse 313004P)
ST10 : 3AG, 6.25 amp (Littlefuse 3136.25P)
See the ST5/10-S Hardware Manual for more information about
power supply and fuse selection.
Connection Panel
920-0005 C