KEYENCE DV-90 - Manual (Page 74)

4-14 E DV-90-IM
4
Ba
si
c
Func
tions
4-3 Active Verification
4
Specify the active verification function
Place the cursor on “1: Active” by pressing the
and key. Then, press the key.
5
Exit the setting mode.
Press the key twice.
Setting of the active verification function is completed.
Presetting the Master Data (Preset Mode)
The same procedure used when setting normal verification is used to preset the master data. (
Refer to 4-5)
Selecting the Active Record
Select the data to verify (active record) in the active verification function. The four methods for
selecting the active record are as follows:
(1) Via DV-90 panel buttons
Selects the active record from the DV-90 front panel.
(2) With the code reader
Selects the active record by reading the data with the code reader connected to the DV-90.
(3) By serial communication command
Selects the active record via serial commands. ( Refer to 8-11)
(4) By PLC link
Selects the active record using the PLC link. ( Refer to 9-4)
„ Via DV-90 panel buttons
This method is used to select the active record while viewing the record number.
1
Select the active record.
Select the record number by pressing the or
key.
Note
The master table is initialized when the verification type is changed.
However, it is not initialized when active verification is changed to normal verification.
Note
• I/O cannot be used to select or change the active record.
• When you are using the PLC link, you cannot use methods (1) to (3).
0 1 V e r i f y T y p e
1 : x x x x x
ESC
1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7
M 1 :