KEYENCE DV-90 - Manual (Page 28)

2-4
2
Initial Setup
of the Cod
e
Reade
r
E DV-90-IM
7
Wire the trigger input (input to starting reading).
⇒ Refer to 3-4.
• If a hand-held reader is connected, no wiring is required.
• For the BL-1300/700/600/180 Series and the SR-600/500, wire the trigger input to the DV-
90.
8
Wire the I/O terminals.
⇒ Refer to 3-2.
9
If you want to communicate with a device such as a PC or a PLC, connect the
DV-90 to the device.
⇒ Refer to 3-10.
For the communication control and operation methods according to the connected device, refer
to the following pages.
• PC (serial communication)
⇒
Refer to 8-1.
• PLC (PLC link)
⇒
Refer to 9-1.
10
Use the DV-90 and confirm its operation is correct.
The DV-90 setup and connections is complete.
2-1 Code Reader Setup Basics