KEYENCE DV-90 - Manual (Page 240)

Appendix-4 E DV-90-IM
App
endix
3
Error Messages
„ This message is displayed when an error occurs upon connection with the code reader
(BL-1300/700/600/180, SR-600/500 Series)
The message is displayed if the code cannot be read when
the read error check is set.
The connection condition of the reader and the printing
quality of the barcode or 2D code must be checked.
The connection condition of the reader and the printing
quality of the barcode must be checked.
„ This message is displayed when the send buffer (4000 bytes) overflows. ( Refer to 8-4)
The message is canceled when the key is pressed, but
the data in the buffer will be cleared.
„ This message is displayed when the receive buffer (2000 bytes) overflows.
The message is canceled when the is pressed, but the
data in the buffer will be cleared.
„ This message is displayed when a PLC link error occurs. ( Refer to 9-36)
The message is cancelled when the key is pressed.
„ This message is displayed when an abnormality occurs while saving data in Flash ROM.
The message is cancelled when the key is pressed.
„ This message is displayed when the master data is illegal while being registered in the
preset mode.( Refer to 4-23)
Enter the correct master data.
Reference
If "ERR**" or a similar message is displayed on the DV-90 screen, an error is being gener-
ated by the connected reader. Use the connected reader's user's manual to check the error
details.
R e a d E r r o r ( C R 1 )
S n d B u f f e r O v e r
[ E S C ]
ESC
R c v B u f f e r O v e r
[ E S C ]
ESC
P L C L i n k E r r o r
[ E S C ]
P L C L i n k E r r o r
I n v a l i d D M [ E S C ]
P L C L i n k E r r o r
A c t i v e N o [ E S C ]
ESC
S a v e E r r o r
[ E S C ]
ESC
F o r m a t E r r o r
M 1 :