KEYENCE DV-90 - Manual (Page 180)

8-2 E DV-90-IM
8
Ser
ia
l Comm
unicati
on
8-1
Serial Communication
With serial communication, you can send data to the PC, and control the DV-90 by sending commands from the
PC.
PORT2 or the USB can be used for serial communication.
Communication Form
There are two types of serial communication:
„ Data communication
Data that is read with the connected code reader can be sent to a PC, etc.
„ Command communication
Commands can be sent from the PC to control the DV-90 directly or to change the settings.
Settings for Serial Communication
To execute serial communication, specify the following settings for the DV-90:
„ Using PORT2
1
Set “PORT2 Unit” in “Main” to “PC”.
2
Specify “Baud” and “Format (data length, parity, stop bit length)” in “PORT2
Unit” according to the PC.
The default settings are as follows:
* When a 2D code reader is connected, and there are double-byte characters such as Chinese
characters in the 2D code being read, set the "Data length" to "8 bits".
3
Specify the “Send Format” in “Verify” according to the software specifications.
( Refer to 6-7)
The default setting is [Data]+ .
4
Specify the “Comm. Protocol” in “Verify” according to the PC software as
required. Normally, there is no need to change this setting.
5
Specify “RTS/CTS” in “PORT2” according to the PC software. Normally, there is
no need to change this setting.
Baud rate 9,600 bits/s
Data length * 7 bits
Parity Even
Stop bit length 1 bit
CR