KEYENCE DV-90 User Manual
Page 43
3-9
3
C
on
necti
ons
and
M
ounti
ng
E DV-90-IM
Connecting the BL-1300 Series or the SR-600/500 Series
To connect the BL-1300 Series or the SR-600/500 Series, use the OP-80616 conversion cable.
Connecting the N-400 or N-410
■ Connecting the BL-U1
Connecting the N-R2 or BL-U2
If you do not want to connect the photoelectric switch for the trigger input (timing input)
directly to each one of the BL-U1, BL-U2, N-R2, N-400 and N-410 (in multiple head mode),
but want to connect it to the trigger input terminal on the DV-90, set the setting of the “Trig-
ger Mode” of PORT1/2 to “Software”. For the setting of “Trigger Mode”, refer to page 6-9.
BL-1300 or SR-600/500
The cable length of OP-80616 is 200 mm.
12-pin round
(female)
9-pin D-sub
(female)
# 4-40 screw
Connector case
• In the output terminal setting
on the BL-1300 Series and the
SR-600 Series, set OUT1 to
OK and OUT2 to NG+ERROR.
• On the SR-500 Series, set as
“NG is output when the read
error occurs”.
The connections can be established via the optional
cable OP-22149 (1.5m) and the conversion con-
necter OP-25057.
The connections can be established via the optional
cable OP-29860 (1.5 m).
Connector case
Connector case
25-pin D-sub
(male)
M2.6 screw
9-pin D-sub
(female)
# 4-40 screw
25-pin D-sub
(male)
M2.6 screw
9-pin D-sub
(female)
# 4-40 screw
N-R2 or BL-U2
The connections can be established via the optional
cable OP-29859 (1.5 m).
Connector case
Connector case
25-pin D-sub
(female)
M2.6 screw
9-pin D-sub
(female)
# 4-40 screw