KEYENCE DV-90 User Manual
Page 31
2-7
2
Initial Setup
of the Cod
e
Reade
r
E DV-90-IM
5
Configure the PC communication conditions on the setup software.
BL SetUp Software
Configure “PC Port Setting” as follows:
• When connected to USB
• Port
: Specify the port No. of the USB.
• Baud rate
: 115200 bits/s
• Data length
: 8 bits
• Parity
: Even
• Stop bit length : 1 bit
• When connected to PORT2
• Port
: Specify the port No. of the RS-232C.
• Baud rate
: 9600 bits/s
• Data length
: 7 bits
• Parity
: Even
• Stop bit length : 1 bit
AutoID Navigator
Configure “Option” as follows:
• When connected to USB
• Port
: Specify the port No. of the USB.
* If the port settings are correct, other settings are not required.
• When connected to PORT2
• Port
: Specify the port No. of the RS-232C.
• Connection method
: Check DV-90 PC Direct.
• Baud rate
: 115200 bits/s
• Data length
: 8 bits
• Parity
: Even
• Stop bit length
: 1 bit
6
Send the settings from the setup software.
The parallel input/output LEDs on the DV-90 illuminate
one by one in sequence during communication. The
commands being communicated are displayed on the
LCD.
7
Press the
key on the DV-90 to exit “PC
Direct”.
The settings are completed.
Setting Procedure Using "Quick Setup Code"(DV-90 SetUp Software)
The settings of the code reader can also be configured by reading the barcode on the “Code
Reader "Quick Setup Code" printed from the DV-90 SetUp Software (BL-700/600/500/180).
⇒ Refer to 7-31.
Note
If the settings cannot be sent due to the processing speed of the computer, change the
timeout to its maximum value (60 sec).
12
11
10
9
8
7
6
5
4
TRG1
TRG2
3
2
1
<
S E N D
>
O K
ESC