KEYENCE DV-90 User Manual

Page 197

8-19

E DV-90-IM

Ser

l Comm

unicati

8-3 Command Communication Details

Master table settings

Master table registration

The master table registration command sends data in the form connecting each data in the master

table with a

(0x09) delimiter after MSET.

The data to be used depends on the specified “Verify Type”, and the command format differs

accordingly. Refer to the table below. As for the representation of the respective data, refer to the

table on the next page.

(Command formats)

• There are some formats in which there is no follower after

. For these formats, do not add

data but instead send

continuously.

• In a case where the data is not changed from the default setting, the data can be omitted. In such a

case, send

continuously, e.g.

without adding any data.

However, when omitting data that is already registered, the data is initialized.

• When not using all the master tables (for example, Master 2 and Master 3 are not used), send only

the data to be used. Omit any subsequent data.
However, do not omit the “Verify Type” and “Record number”.

• It is possible to change the output number alone in the “Settings for record number 0, and 997

through 999”.

Verify Normal

Verify Active

Verify Step

Verify 3points-A
Verify 3points-B

Settings for record number 0,

and 997 through 999

MSET [Verify Type]

[Record number]

[Output number]

[Port]

[Reference data]

[Master data 1]

[Designation 1]

[Limit Direction 1]

[Limit Start 1]

[Limit Digits 1]

[Limit Logic 1]

[Master data 2]

[Designation 2]

[Limit Direction 2]

[Limit Start 2]

[Limit Digits 2]

[Limit Logic 2]

[Master data 3]

[Designation 3]

[Limit Direction 3]

[Limit Start 3]

[Limit Digits 3]

[Limit Logic 3]

MSET [Verify Type]

[Record number]

[Reference data]

[Master data 1]

MSET [Verify Type]

[Record number]

[Output number]

[Reference data]

[Master data 1]

[Designation 1]

[Limit Direction 1]

[Limit Start 1]

[Limit Digits 1]

[Master data 2]

[Designation 2]

[Limit Direction 2]

[Limit Start 2]

[Limit Digits 2]

[Master data 3]

[Designation 3]

[Limit Direction 3]

[Limit Start 3]

[Limit Digits 3]

MSET [Verify Type]

[Record number]

[Output number]