KEYENCE DV-90 User Manual
Page 24
1-12
E DV-90-IM
1
Getti
ng Started
∗ 1 PORT1 can connect a barcode reader.
∗ 2
PORT2 can connect either a barcode reader, PC or PLC.
∗ 3
USB can connect a PC.
The supported operating systems are Windows 8/7/Vista/XP/2000.
∗ 4
The I/O terminal has 4 input pins and 16 output pins.
The NPN open collector output type (DV-90NE) and the PNP open collector output type
(DV-90PE) are available for output.
∗ 5
The barcode readers that can be directly connected to PORT1 or PORT2 are the BL-700/600/
180 Series, HR-40RK/50RK, and BL-210RK/N70RKE. For the BL-1300 Series, SR Series,
TL-800/70R, and HR-30R/HR-UC51, a connector cable must be prepared separately.
The barcode reader directly connected to PORT1 or PORT2 are powered from the
connected port. The maximum +5V DC power current that can be supplied to PORT1
and PORT2 is 1100 mA in total. Ensure that the power consumption of the connected
barcode reader stays under this limit.
However, when the ambient temperature exceeds 40 °C, the maximum power current
that can be supplied is 850 mA.
∗ 6
The SetUp Software is used when changing the internal settings of the DV-90.
The settings can be changed on the PC that is connected to USB or PORT2.
∗ 7
In the communication with a PLC, non-procedural communication (An RS-232C unit that can
establish non-procedural communication is required on the PLC side. Consult with the PLC
manufacturer.) or communication by the dedicated protocol for the PLC manufacturer (PLC
link) is available.
The following models of PLC are available for PLC link.
Keyence KV Series
Mitsubishi Electric MELSEC Series
Omron SYSMAC Series
Connectable combinations
Since PORT1, PORT2, and USB function independently, the connecting devices can be opted for
independently as well.
The following list shows the connectable combinations.
PORT1
PORT2
USB
Code reader
-
-
Code reader
PC
-
Code reader
-
PC
Code reader
PC
PC
Code reader
PLC
-
Code reader
PLC
PC
Code reader
Code reader
-
Code reader
Code reader
PC