KEYENCE DV-90 User Manual
Page 27
2-3
2
Initial Setup
of the Cod
e
Reade
r
E DV-90-IM
3
Connect the code reader to PORT1 of the DV-90.
⇒
Refer to 3-8.
Turn off the power of the DV-90 when connecting the code reader.
4
Read the data with the code reader, and confirm that the data is displayed on the
LCD of the DV-90.
• If you are using the BL-1300/700/600 or the SR Series, the data can be read by gently press-
ing the [TEST] switch on the DV-90 once.
• If you are using the BL-180, perform the following key operations on the DV-90. (The same
operations are valid on the BL-1300/700/600 and the SR-600/500.)
(1) Press the
key on the DV-90.
(2) Select “CR1” by pressing the
key on the DV-90.
(3) Press the
key on the DV-90 and reading starts.
5
Change the code reader settings
(such as the type of barcode to read).
• For the HR-50RK/40RK/UC51, BL-210RK/N70RK/N9R, and TL-800/70R, refer to the
respective manuals to change the settings.
• For the BL-700/600/180 Series, configure the settings on the BL SetUp Software.
⇒
Refer to “BL Series User’s Manual”.
• The settings are made on Auto ID Navigator for the BL-1300 and the SR-600/500.
⇒
Refer to “BL-1300 Series and SR Series User's Manual”.
6
According to the purpose of use, change the settings of the DV-90.
The settings of the DV-90 can be changed in the following methods.
• Key operations on the DV-90
⇒
Refer to 6
-1.
• DV-90 SetUp Software
⇒
Refer to
7-1.
1 2 3 4 5 6 7 8 9 0
TRG