Metrohm IC Net 2.3 - Manual (Page 89)

6.4 819 IC Detector
IC Net 2.3 79
The Program tab contains the two following subpages:
Program Main time program with all program
steps.
Remote configuration Possibility for creation of user-defined
remote commands.
Program
On the Program subpage, program steps including time, program
instruction and parameter can be entered.
First column Time at which program instruction is ap-
plied.
Entry range:
0.0 ... 999.9 min
If no time is entered, the program instruc-
tion is applied together with the last instruc-
tion with time entry.
Second column Program instruction (see below).
In addition to these predefined instructions,
user-defined remote commands can be en-
tered if activated on the
Remote configura-
tion tab.
Third column Parameter for program instruction (see be-
low).
ENABLED Enable program start (a disabled program
is not started).