Metrohm IC Net 2.3 - Manual (Page 57)

5.2 762 IC Interface
IC Net 2.3 47
The Program tab contains the two following subpages:
Program
Main time program with all program steps.
Events configuration Possibility for creation of user-defined re-
mote commands.
Program
On the Program subpage, program steps including time, program
instruction and parameter can be entered.
First column Time at which program instruction is ap-
plied.
Entry range:
0.0 ... 999.9 min
If no time is entered, the program instruc-
tion is applied together with the last instruc-
tion with time entry.
Second column Program instruction (see below).
In addition to these predefined instructions,
user-defined remote commands can be en-
tered if activated on the
Events configuration
tab.
Third column Parameter for program instruction (see be-
low).
ENABLED Enable program start (a disabled program
is not started).
Add new program instruction.
Delete selected program instruction.
Test the time program (error messages are
displayed if program is wrong).
List of program instructions
The following program instructions can be added to the time pro-
gram on the
Program subpage:
Instruction Parameter entry Meaning
Events 0, 1, p, * Set event output lines 1...7 to the
desired values. For entry of the first
value, enter 1 , 0 , p or * . For entry of
the other values, move the cursor in
front of the value to be changed
and enter 1 , 0 , p or * .