Metrohm IC Net 2.3 - Manual (Page 201)

6.24 788 IC Filtration Sample Processor
IC Net 2.3 191
Ctrl "control
command"
Set the specified remote output
signal. In addition to the normal
control commands (details see 788
Instruction for Use) special
commands defined on the Configu-
ration tab can be used.
Wait 1...9999 s
Waiting time.
StartDA Start data acquisition.
Configuration
The Configuration tab of the 788 IC Filtration Sample Processor win-
dow contains parameters settings on the five subtabs Rack , Vial
positions , Needle positions , Control , and Scan .
Rack
Rack definitions
Code
Binary ID code for rack identification (read-
only).
Type Predefined rack type (read-only).
Settings
Maximum lift way Definition of lowest lift position possible in
mm.
Entry range:
0...125 mm
Send parameters to 788 IC Filtration Sam-
ple Processor.
Read current parameters from 788 IC Filtra-
tion Sample Processor.