Metrohm IC Net 2.3 - Manual (Page 106)

6 Devices
IC Net 2.3 96
Valve Manual switching of the injection valve at
the 812 Valve Unit:
Switch injection valve to "Fill" position (con-
trol line
Cont1 is set to 0).
Switch injection valve to "Inject" position
(control line
Cont1 is set to 1).
Analog output Manual setting of the analog output signal
to zero.
Trigger the autozero function.
Actual Display of actual values.
Mode Display of current detector mode.
Cell Display of current cell state.
Oven Display of current ovent state.
Control Display of current control line settings.
DC mode
The DC mode subtab of the Method parameters tab on the 817 Bio-
scan window is used to set the parameters for the DC mode. This
window is only available if Mode has been set to DC on the Manual
tab.