Metrohm IC Net 2.3 - Manual (Page 58)

5 Interfaces
IC Net 2.3 48
Program END, RESET The END flag can be used to end a
program, especially if the program
time should be longer than the
chromatogram duration. Additional
steps after this flag are not allowed.
The RESET flag is used to reset the
parameters to the system startup
values.
Events configuration
On the Events configuration subtab user-defined event commands
can be defined, which can be inserted into a time program after
being activated with
.
Name (1 st column) User-definable name of the event com-
mand (e.g.
Start_766 ).
Event command (2 nd column)
Setting the event output lines 1 … 7.
Selection:
0 (line off, inactive, open)
1 (line on, active, 0 V)
p (pulse, pulse length 150 ms)
*
(leave line in current status)
For entry of the first value, enter 1 , 0 , p or * .
For entry of the other values, move the cur-
sor in front of the value to be changed and
enter
1 , 0 , p or * .
Add new remote command.
Delete selected remote command.
Activate the defined remote commands for
insertion into the time program.