Lenze EVS93xx CrossCutter - Manual (Page 33)

Cross Cutter
Features of the "Cross Cutter" prepared solution
Prepared Solution Servo PLC / ECSxA 1.1 EN 2-19
Figure 2: Important motion profile positions dependent on the number of knives
Variable names
Global variables (Variable type: VAR_GLOBAL)
Name Data type Value/Meaning
Start and stop of cross cutter operation
TRUE
The cross cutter moves to its base
position and starts cross cutter operation
as long as there is line speed.
g_bStartStopOperation BOOL
FALSE Cross cutter operation stops and the
cross cutter moves to its base position.
Abort of cross cutter operation
TRUE
Abort Cross cutter operation
Attention: Use only when line speed is
zero!
g_bAbordCrossCutter BOOL
FALSE There is no abort of cross cutter
operation.
Possible settings: Code
Default Selection
Comment
Application control word bit 14: Start and stop of cross cutter
operation.
TRUE Start of operation
C4135/
000
Bit 14
0 0 {1} 1
FALSE Stop of operation
Application control word bit 24: Abort of cross cutter operation.
TRUE Abort of operation
C4135/
000
Bit 24
0 0 {1} 1
FALSE No abort of operation
C3694/
000
- - {1[s_units]} - Display code: Basic position or starting position of the cross
cutter.
- One knife connected to the
cross cutter drum
- Cutting angle φ= 30° - Two knives connected to the
cross cutter drum
- Cutting angle φ = 30° - Four knives connected to the
cross cutter drum
- Cutting angle φ = 30°
basic position basic position
cutting angle φ cutting angle φ