Lenze EVS93xx CrossCutter - Manual (Page 243)

Cross Cutter
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 6-75
Click on the code and select the required control bit.
Example: Bit 31 is to be used to control manual jog in a positive direction on the cross-cutter axis. Set
C4010/004 = 31 accordingly and confirm your entry with Ok.
To reconfigure other control bits, proceed as described in Step 1.
Save the modified settings to non-volatile memory with C0003/000 = 1.
End
?
YES ⇒ 1
NO
Step 3
Step 2