Lenze EVS93xx CrossCutter - Manual (Page 153)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
Prepared Solution Servo PLC / ECSxA 1.1 EN 3-139
You now need to check, in the application status word, that the conditions for starting the cross cutter in length-
controlled operation have been met (Short Setup Control/Status Interface Status Interface):
Click code C4150/000 to open the application status word.
The following bits have to be set to start length-controlled operation:
Bit 12 Cutting profile calculation OK
Bit 13
Reject profile calculation OK
Bit 14 Test profile calculation OK
Bit 15 Start/stop profile calculation OK
Bit 17 Home position detected
Bit 31 Profile calculation complete
The following bits must not be set to start length-controlled operation:
Bit 0 Error status
Bit 1
Following error warning
Bit 2 Following error disconnection
Bit 18 Homing error
Check the following code:
C3505/000 The system must be in standby (10).
Step 5