Lenze EVS93xx CrossCutter - Manual (Page 177)

Cross Cutter
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 6-9
Outputs
Global variables (Variable type: VAR_GLOBAL)
Name Data type Value/Meaning
Status of calculation sequence for new reject length.
0 Calculation ok.
1 • No LC9 file found.
• Profile data not found in absolute
data model.
• Read error when accessing profile
data.
2 Selected motion profile not found.
4 The angle of motion of the knife drum for
the asynchronous motion phase is less
than or equal to zero (check y final value
of basic profile and cutting angle!).
8 A value of zero has been entered for the
knife drum's cutting circle circumference.
16 The preset cutting length is less than the
material length corresponding to the
cutting angle.
32 The selected motion profile contains
fewer than 20 interpolation points.
64 The selected motion profile does not
start at zero (0.0000/0.0000).
128 Cutting angle too small.
256 The y final value of the basic profile
does not correspond to value
360.0000[°]/n
cuts/rev
.
(n
cuts/rev
= Number of knives on knife
drum, values of 1, 2, 3, 4, 5 or 6 are
possible)
512 Internal read access to code C0011 failed.
g_nCrossCutterCalcStateRejectProfile INT
If the nState status variable is exhibiting non-zero values, the calculated variables
may exhibit invalid values, in which case it will not be possible to use them
subsequently in the control program!