Lenze EVS93xx CrossCutter - Manual (Page 202)

Cross Cutter
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 6-34
6.1.18 VarVertShaftExtPosition
Inputs
Global variables (Variable type: VAR_GLOBAL)
Name Data type Value/Meaning
Enable external master signal.
TRUE
X axis defined externally.
g_bVertShaftExtEnable BOOL
FALSE X axis generated by virtual master.
Positioning to external master angle
TRUE
Positioning to external master angle.
g_bPosToVertShaftExt BOOL
FALSE Direct switch to external master angle.
6.1.19 VarVertShaftExtVelocity
Inputs
Global variables (Variable type: VAR_GLOBAL)
Name Data type Value/Meaning
Selection of external master signal
TRUE Digital
frequency via digital frequency
input DFIN.
g_bTypeOfVertShaftExt BOOL
FALSE Master angle via system bus (CAN).
Selection of operating mode
0 Continuous
operation
The external digital frequency entry is
integrated continuously.
g_byVertShaftExtVelMode BYTE
1 Start/stop operation
The external digital frequency entry is
only integrated when a corresponding
start/stop signal is pending at
g_bStartStopVertShaftExtVel.
Start/stop signal for "Start/stop operation"
TRUE Start
integration.
Integration will continue at least until the
next zero crossing.
g_bStartStopVertShaftExtVel BOOL
FALSE No integration/abort previously activated
integration on the next zero crossing.
g_nVertShaftExt_v INT Entry indicating the external digital frequency/speed in [incr./ms]
Invert external digital frequency entry.
g_bVertShaftExtVelCwCcw BOOL
TRUE g_nVertShaftExt_v inverted internally.