Lenze EVS93xx CrossCutter - Manual (Page 246)

Cross Cutter
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 6-78
Click on the code and select the status information you wish to assign to this status bit for display.
Example: If you wish to see the "Homing in progress" signal, select C4012/007 = 16 (Homing in progress) and
confirm with Ok.
To reconfigure other status bits, proceed as described in Step 1.
Save the modified settings to non-volatile memory with C0003/000 = 1.
TIP!
Regardless of the operating mode you select via C4000/000, the application status word will be
displayed via code C4150/000.
End
?
YES ⇒ 1
NO
Step 3
Step 2