Avaya Cajun P550R - Manual (Page 95)

Chapter 5
5-8 Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
set console transfer ppp
Command Mode
Configuration
Description
Transfers control of the serial console port and the CLI session to the
PPP protocol layer.
This command is only accepted when the console serial port is
configured in PPP mode.
When accepted, this command immediately terminates the current
CLI session, logs the user out, and switches the I/O on the serial
console port from the CLI processing software to the PPP layer. The
remote host also needs to simultaneously change its I/O to use PPP
software. This command is NOT stored (no back-end), and is only
for use when the user has successfully dialed-into the switch. This
command can only be accepted when the Console Serial Port is
configured in PPP mode.
The command cannot be accepted from a telnet session, it can only
be accepted over directly connected serial sessions, and most
preferably from a post-dial modem terminal session on the remote
host.
Syntax
Sample Output
The following example sets the console transfer ppp.
# set console transfer ppp
Systems
Avaya P550R/P580/P880/P882 Multiservice Switch
To Enable: set console transfer ppp