Avaya Cajun P550R - Manual (Page 233)

Chapter 12
12-16 Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
ipx rip-filter
Command Mode
Interface
Description
Controls which networks are present in RIP packets sent and
received on the interface. The no form of this command removes
the filter from an interface.
Syntax
Table 12-6. Parameters, Keywords, Arguments
To Enable: ipx rip-filter
{outbound|inbound|both} {filter| allow} [ []]
To Disable: [no] ipx rip-filter
{outbound | inbound | both} {filter | allow} [ [hops>]]
Name Definition
precedence Indicates the precedence of this RIP filter in relation to other RIP filters on this
interface. Lower numbers indicate a higher precedence. The range is 0-9999.
start-
network The first IPX network address this filter should match. The range is 0-FFFFFFFF.
end-
network The last IPX network address this filter should match. The range is 0-FFFFFFFF.
outbound|in
bound| both The filter direction.
• outbound - apply filter to RIP packets sent out the interface.
• inbound - apply filter to RIP packets received on the interface.
• both - apply filter to RIP packets in both directions.
filter|allow The action to take for the IPX network in question.
• filter - do not add the network to the routing table (inbound RIP packets)
or do not advertise the network (outbound RIP packets).
• allow - add the network to the routing table (inbound RIP packets)
or advertise the network (outbound RIP packets).
filter-ticks Modify the number of ticks to get to the network in the routing table (inbound
RIP packets) or in the advertised information (outbound RIP packets). The range
is 0 to 32000 ticks.
filter-hops Modify the number of hops to get to the network in the routing table (inbound
RIP packets) or in the advertised information (outbound RIP packets). The range
is 0 to 16 hops.