Avaya Cajun P550R - Manual (Page 92)

Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1 5-5
Console
set console initcmd
Command Mode
Configuration
Description
Sets the modem initialization string for console serial port modem
control software. The default Modem Configuration String is
AT&D0S0=1.
* Note: This command is not applicable when the console serial
port is configured in TTY mode. The input will not be
accepted or stored when the serial port is configured in
TTY mode.
The init command string is used to configure the
attached external modem so that dial-in sessions will be
properly accepted by the modem and the connection
successfully completed between the switch and the
remote system. The set console initcmd is only accepted
when the console serial port is configured as PPP mode.
Please read your modem’s reference literature to find
the correct AT parameters.
There are few configurations and Avaya recommended
modems that do not require a modem initialization
string.
Syntax
Table 5-4. Parameters, Keywords, Arguments
Sample Output
The following example sets the console initialization
command with an initialization string of AT&D080=1
# set console initcmd AT&D0S0=1
Systems
Avaya P550R/P580/P880/P882 Multiservice Switch
To Enable: set console initcmd [init_cmd_string]
Name Definition
[init_cmd_string] An optional parameter, however, when the parameter is
missing, it means that the modem initialization string is .