Avaya Cajun P550R - Manual (Page 427)

Chapter 21
21-24 Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
set port flow-control
Command Mode
Configuration
Description
Set the port flow control.
* Note: Setting this parameter on any M5548-100TX port
(Tamale) sets all physical ports on the module to the
same value.
Syntax
Table 21-19. Parameters, Keywords, Arguments
To Enable: set port flow-control {|}
[...,{|}]{disable|enable|enable-receive-
only|enable-send-only|
enable-with-aggressive-backoff}
Name Definition
mod-num Specifies the number of the module where the flow control for each
port on the module is to be set.
mod-port-range Specifies the range of ports whose flow control is to be set.
flowcontrol The Flow Control options are:
• disable - Disables flow control for specified ports. Turns off an
attached device's ability to send flow-control packets to a local port.
• enable - Enables flow control for specified ports. Turns on an attached
device's ability to send flow-control packets to a local port.
• enable-receive-only - Enables receive only for the specified gigabit
ports. Indicates that a port only receives administrative status from a
remote device.
• enable-send-only - Enables send only for the specified gigabit ports.
Indicates that a port only sends administrative status from a remote
device.
• enable-with-aggressive-backoff - Enables flow control with
aggressive backoff for specified fast ethernet ports.