Avaya Cajun P550R - Manual (Page 187)

Chapter 10
10-32 Command Reference for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
ip routing-mode
Command Mode
Configure
Description
Sets the IP routing mode on an interface. The no form of this
command restores the default setting to RT_MGMT.
Syntax
Sample Output
This example enables local packet consumption and disables IP
forwarding on an interface labeled “boston”.
(config-if:boston)#
ip routing-mode MGMT_ONLY
Systems
Avaya P550R/P580/P880/P882 Multiservice Switch
To Enable: ip routing-mode {RT_MGMT | RT_ONLY | MGMT_ONLY}
To Disable: [no] ip routing-mode
Table 10-17. Parameters, Keywords, Arguments
Name Definition
{RT_MGMT |
RT_ONLY |
MGMT_ONLY} • Routing/Mgmt - IP routing is enabled on
the interface, and you can manage the switch
through the interface (from the CLI or Web
Agent).
• Mgmt Only - You can manage the switch
through the interface (from the CLI or Web
Agent), but IP routing is disabled on the
interface.
Note: Do not enable routing protocols on an
interface configured for Mgmt Only since
the interface will act as an end point and
will not pass traffic.
• Routing Only - Routing only interfaces do
not permit management traffic destined for
local interfaces but do allow all other traffic
including management traffic destined for
interfaces on other switches..