Avaya Cajun P550R - Manual (Page 249)

Chapter 12
12-32 Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
ipx service
Command Mode
Configure
Description
Specifies static SAP entries. To remove static SAP entries, use the no
form of this command. The default is that no static services are
defined.
Syntax
Table 12-15. Parameters, Keywords, Arguments
To Enable: ipx service
To Disable: [no] ipx service
Name Definition
service-type The number of the type of the service. The range is 0-FFFF.
service-name Name of the server that provides the service. The range is 1 to
47 bytes long.
network, node Network number and node address of the server.
• The argument network is an eight-digit hexadecimal
number that uniquely identifies a network cable segment.
It can be a number in the range 1 to FFFFFFFD. You do
not need to specify leading zeros in the network number.
For example, for the network number 000000AA you can
enter AA.
• The argument node is the node number of the target
Novell server. This is a 48-bit value represented by a MAC
address (aa:bb:cc:dd:ee:ff).
socket The socket number for this service. The range is 0 - FFFF
network.next-hop-node Network number and node address of the next hop to the
server.
- The argument node is the node number of
the target Novell server. This is a 48-bit value represented by a
MAC address (aa:bb:cc:dd:ee:ff).
hops Number of hops to the server. The range is 1-16.