Allied Telesis AT-S62 - Manual (Page 59)

AT-S62 Web Browser Interface User’s Guide
Section I: Basic Operations 59
The Port Configuration page is shown Figure 16.
Figure 16 Port Configuration Page
Note
The Port Configuration page in the figure above is for a 10/100 Mbps
twisted pair port. The page for a fiber optic port will contain a subset
of the parameters.
If you are configuring multiple ports and the ports have different
settings, the Port Configuration menu displays the settings of the
lowest numbered port. Once you have configured the settings of
the port, all of its settings are copied to the other selected ports.
The Defaults button returns the port settings to the default
values, which are listed in Appendix A in the AT-S62 Menus
Interface User’s Guide.
6. Adjust the port parameters as needed.
The parameters are described below.
Port Name
You use this selection to assign a name to a port. The name can be
from one to fifteen alphanumeric characters. Spaces are allowed,
but you should not use special characters, such as asterisks or
exclamation points. (You cannot assign a name when you are
configuring more than one port.)
Speed and Duplex
You use this selection to configure the speed and duplex mode of
a port. For a twisted pair port, you can select Auto-Negotiation or
you can set its speed and duplex mode manually. For a fiber optic
port, you can set the duplex mode.