Allied Telesis AT-S62 - Manual (Page 306)

Chapter 25: 802.1x Port-based Access Control
Section VI: Port Security 306
Configuring Supplicant Port Parameters
To configure supplicant port parameters, perform the following
procedure:
1. From the 802.1x Port Access tab shown in Figure 108 on page 298,
click the supplicant port that you want to configure. You can select
more that one supplicant port at a time. The selected port turns white.
Note
A port must already be designated as a supplicant before you can
configure its settings. For instructions on how to set the role of a
port, refer to Setting Port Roles on page 300.
2. Click Settings.
The Supplicant Parameters page is shown in Figure 110.
Figure 111 Supplicant Parameters Page
3. Adjust the parameters as needed. The parameters are described
below:
Auth Period
Specifies the period of time in seconds that the supplicant will
wait for a reply from the authenticator after sending an EAP-
Response frame. The range is 1 to 60 seconds. The default is 30
seconds.