Allied Telesis AT-S62 - Manual (Page 321)

AT-S62 Web Browser Interface User’s Guide
Section VII: Management Security 321
Configuring RADIUS and TACACS+
To configure the authentication protocols, perform the following
procedure:
1. From the Home Page, select Configuration.
2. Select the Mgmt. Protocols menu selection.
3. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 116.
Figure 116 Server-based Authentication Tab (Configuration)
Note
The Enable Server-based Authentication check box applies only to
new manager accounts. It does not apply to 802.1x port-based
access control.
4. To select an authentication protocol, click either RADIUS or TACACS+
in the Authentication Method section of the tab. The default is
TACACS+.
Note
The switch can support only one authentication protocol at a time.
Additionally, you cannot select a different authenticator protocol
when this feature is enabled.