Allied Telesis AT-S62 - Manual (Page 327)

AT-S62 Web Browser Interface User’s Guide
Section VII: Management Security 327
Creating a Management ACL
To create a Management ACL, perform the following procedure:
Note
Activating the Management ACL without specifying any ACEs will
block you from managing the device remotely.
1. From the Home Page, select Configuration.
2. Select the Mgmt Security menu option.
This menu option has only one tab, Mgmt ACL, shown in Figure
119.
Figure 119 Mgmt. ACL Tab (Configuration)
ACEs already existing in the Management ACL are listed in the
middle section of the tab.
3. To add a new ACE, in the Mgmt. ACL IP Address field enter the IP
address of a specific management workstation (for example,
149.11.11.11) or a subnet. You must enter an IP address. If you enter
an IP address of a specific management node, then that node will be
permitted remote management access to the switch. If you enter a
subnet, any management node in the subnet will be permitted
remote management access to the switch.