Allied Telesis AT-S62 - Manual (Page 117)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 117
7. To permanently save the change, click the Save Config menu
selection.
Modifying a
Syslog Server
Definition
To modify a syslog server definition, perform the following procedure:
1. From the Home Page, click Configuration.
2. Select the System menu selection.
3. Select the Event Log tab.
The Event Log tab is shown in Figure 29 on page 105.
4. In the Current Log Outputs section of the tab, click the syslog entry
you want to modify and click Modify.
The Modify Event Log Output window for the selected syslog
definition is displayed.
5. Configure the parameter settings as needed. For descriptions of the
parameters, refer to Creating a Syslog Server Definition on page 113.
6. After you finish configuring the parameters, click Apply.
Changes to a syslog definition are immediately activated on the
switch.
7. To permanently save the change, click the Save Config menu
selection.
Deleting a Syslog
Server Definition
To delete a syslog server definition, perform the following procedure:
1. From the Home Page, click Configuration.
2. Select the System menu option.
3. Select the Event Log tab.
The Event Log tab is shown in Figure 29 on page 105.
4. In the Current Log Outputs section of the tab, click the syslog
definition you want to delete and click Delete.
The selected syslog definition is immediately deleted from the
switch.
5. To permanently save the change, click the Save Config menu
selection.