Allied Telesis AT-S62 - Manual (Page 45)

AT-S62 Web Browser Interface User’s Guide
Section I: Basic Operations 45
Returning the AT-S62 Software to the Factory Default Values
The procedure in this section returns all AT-S62 software parameters,
including IP address and subnet mask, if assigned, to their default values.
Please note the following before performing this procedure:
❑ Returning all parameter settings to their default values also
deletes any port-based or tagged VLANs you created on the
switch.
❑ This procedure retains the files in the switch’s file system as well
as the encryption keys stored in the key database.
❑ Returning a switch to its default values does not alter the contents
of the active boot configuration file. To reset the file back to the
default settings, you must select Save Config from the menu after
the switch reboots and you have reestablished your management
session. Otherwise the switch will revert back to the previous
configuration the next time you reset the unit.
Note
The AT-S62 software default values can be found in Appendix A in
the AT-S62 Menus Interface User’s Guide.
To return the AT-S62 management software to the default settings,
perform the following procedure:
1. From the Home Page, select Configuration.
2. Select Utilities menu option.
3. Select the System Utilities tab.