Allied Telesis AT-S62 - Manual (Page 234)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 234
making changes to an SNMPv3 Community Table entry with a
NonVolatile storage type, the Save Config menu selection
appears.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Community Table entry
takes effect immediately.
11. Click Apply to update the SNMPv3 Community Table.
12. To save your changes, select the Save Config menu selection.
Deleting an
SNMPv3
Community
Table Entry
To delete an entry in the SNMPv3 Community Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 80 on
page 232.
5. Click the circle next to the SNMPv3 Community Table entry that you
want to delete. Then click Remove.
A warning message is displayed. Click OK to remove the SNMPv3
Community Table entry.
6. To save your changes, select the Save Config menu selection.