Allied Telesis AT-S62 - Manual (Page 58)

Chapter 5: Port Parameters
Section I: Basic Operations 58
Configuring Port Parameters
To configure the parameter settings of a port on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Settings tab.
The Port Settings tab is shown in Figure 15.
Figure 15 Port Settings Tab (Configuration)
4. Click the port in the graphical switch image you want to configure.
The selected port turns white. You can configure more than one port
at a time. (To deselect a port, click it again.)
5. Click Modify. To configure all of the base ports (not including any
expansion ports), click Modify All.