Allied Telesis AT-S62 - Manual (Page 113)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 113
Creating a Syslog
Server Definition
To create a syslog server definition, perform the following procedure:
1. From the Home Page, click Configuration.
2. Select the System menu selection.
3. The Event Log tab.
The Event Log tab is shown in Figure 29 on page 105.
4. In the Current Log Outputs section of the tab, click Create.
The Creating Event Log Output Window is shown in Figure 32.
Figure 32 Creating Event Log Output Window
5. Configure the parameters as needed. The parameters are defined
here:
Output ID
The ID number for the syslog server definition. The definition will
be identified in the Configure Log Outputs menu by this number.
The range is 2 to 20. The default is the next available number. You
cannot use a number that is already assigned.
Message Generation
This enables and disables the syslog server definition. If set to
disabled, which is the default, the switch does not send events to
the syslog server. When enabled, the switch sends events. The
default is disabled.
Message Format
The information sent with each event. Choices are:
❑ Normal - sends the severity, module, and description.