Allied Telesis AT-S62 - Manual (Page 264)

Chapter 20: STP, RSTP, and MSTP
Section IV: Spanning Tree Protocols 264
Configuring
MSTP Port
Parameters
To configure MSTP port parameters, perform the following procedure:
1. Perform Steps 1 through 4 in the procedure Configuring MSTP and
CIST Parameters on page 258 to display the Spanning Tree Expanded
Web Page for MSTP.
2. In the diagram of the switch at the bottom of the MSTP Spanning Tree
Expanded Web Page, click the port you want to configure. You can
select more than one port at a time. A selected port turns white.
3. Click Configure.
The MSTP Port Settings window is shown in Figure 99.
Figure 99 MSTP Port Settings Window
4. Adjust the parameters as needed. The parameters are described
below.
The port parameters can be divided into two groups: generic
parameters and MSTI-specific parameters. A generic port
parameter is set just once on a port and applies to all MSTIs where
a port, through its VLAN assignments, is a member. Generic
parameters are:
❑ External path cost
❑ Point-to-point port
❑ Edge port