Allied Telesis AT-S62 - Manual (Page 126)

Chapter 12: Classifiers
Section II: Advanced Operations 126
Modifying a Classifier
This procedure explains how to modify a classifier. If the classifier you
want to modify is currently assigned to an active ACL or QoS policy, you
must first remove the port assignments from the ACL or policy before
you can modify the classifier. Once you have finished modifying the
classifier, you can reassign the ports again to the ACL or QoS policy.
To modify a classifier, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Network Security or Services menu selection. (The
Classifier tab is accessible from both menu selections.)
3. Select the Classifier tab.
The Classifier tab is shown in Figure 33 on page 120.
4. Click the dialog circle next to the classifier you want to modify and
click Modify. You can modify only one classifier at a time.
An example of the Modify Classifier page is shown in Figure 36.
Figure 36 Modify Classifier Page
5. Modify the parameters as necessary. For definitions of the parameter,
refer to Creating a Classifier on page 120.
6. After you have finished modifying the parameters, click Apply.
The modifications are immediately implemented in the classifier.
7. To permanently save your changes, select the Save Config menu
selection.