Allied Telesis AT-S62 - Manual (Page 185)

AT-S62 Web Browser Interface User’s Guide
Section III: SNMPv3 Operations 185
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to configure the SNMPv3
tables. To enable a manager to access the SNMPv3 protocol on the
switch, you need to enable the SNMP protocol. See the following
procedures:
❑ Enabling the SNMP Protocol on page 186
❑ Configuring the SNMPv3 User Table on page 188
❑ Configuring the SNMPv3 View Table on page 195
❑ Configuring the SNMPv3 Access Table on page 201
❑ Configuring the SNMPv3 SecurityToGroup Table on page 208
❑ Configuring the SNMPv3 Notify Table on page 213
❑ Configuring the SNMPv3 Target Address Table on page 218
❑ Configuring the SNMPv3 Target Parameters Table on page 224
❑ Configuring the SNMPv3 Community Table on page 231
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with the SNMPv1 or an SNMPv2c protocol. Allied
Telesyn does not recommend this configuration.
For reference information about the SNMPv3 protocol, refer to the
AT-S62 Menus Interface User’s Guide.