Allied Telesis AT-S62 - Manual (Page 231)

AT-S62 Web Browser Interface User’s Guide
Section III: SNMPv3 Operations 231
Configuring the SNMPv3 Community Table
You can create, delete, and modify an SNMPv3 Community Table entry.
See the following procedures:
❑ Creating an SNMPv3 Community Table Entry on page 231
❑ Deleting an SNMPv3 Community Table Entry on page 234
❑ Modifying an SNMPv3 Community Table Entry on page 235
For reference information about the SNMPv3 Community Table, see
Configuring the SNMPv3 Community Table on page 231.
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.
Creating an
SNMPv3
Community
Table Entry
To create an SNMPv3 Community Table entry, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 80.