Allied Telesis AT-S62 - Manual (Page 292)

Chapter 24: MAC Address Security
Section VI: Port Security 292
Configuring MAC Address Security
MAC address security allows you to control access to a port on the
switch using the MAC addresses of the end nodes. To configure MAC
address security, perform the following procedure:
1. From the Home page, select Configuration.
2. Select the Network Security menu selection.
3. Select the Port Security tab.
The Port Security tab is shown in Figure 105.
Figure 105 Port Security Tab
4. Click the port you want to configure. A selected port turns white. To
deselect a port, click it again. You can configure more than one port
at a time.
5. Click Modify.