Allied Telesis AT-S62 - Manual (Page 130)

Chapter 13: Access Control Lists
Section II: Advanced Operations 130
Creating an Access Control List
This procedure explains how to create an ACL. It is a good idea before
performing this procedure to jot down on paper the ID number(s) of the
classifier(s) you want to assign to the ACL and the action of the ACL,
which is either Permit or Deny. An action of Permit instructs the port to
accept packets from the defined traffic flow of the classifier, while an
action of Deny discards the packets. Having this information handy will
make it easier for you to perform the procedure. To view the classifier ID
numbers and specifications, refer to Displaying the Classifiers on page
128.
To create an access control list, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Network Security menu selection.
3. Select the ACL tab.
The ACL tab is shown in Figure 37.
Figure 37 ACL Tab (Configuration)
The tab lists the access control lists that currently exist on the
switch. The columns in the table are defined here:
ID
The ID number of the ACL.