Allied Telesis AT-S62 - Manual (Page 116)

Chapter 11: Event Log and Syslog Servers
Section II: Advanced Operations 116
❑ LOCAL3
❑ LOCAL4
❑ LOCAL5
❑ LOCAL6
❑ LOCAL7
Each setting represents a predefined RFC 3164 numerical code.
The code mappings are listed in Table 4.
For example, selecting LOCAL2 as the facility level assigns the
numerical code of 18 to all events sent to the syslog server by the
switch.
Module Selections
The originating module of the events to be sent to the syslog
server. The AT-S62 management software consists of a number of
modules, each responsible for a different part of switch operation.
You can use this parameter to instruct the switch to send only
those events that originated from selected modules. The default
is ALL, which sends the events from all modules. The modules are
defined in Table 2 on page 107. To select more than one module,
hold down the Ctrl key when making your selections.
6. After configuring the syslog server definition, click Apply.
The switch adds the new syslog server definition to the Event Log
tab and immediately begins to send events to the server if you
enabled the Message Generation option.
Table 4 Numerical Code and Facility Level Mappings
Numerical
Code
Facility Level Setting
17 LOCAL1
18 LOCAL2
19 LOCAL3
20 LOCAL4
21 LOCAL5
22 LOCAL6
23 LOCAL7