Allied Telesis AT-S62 - Manual (Page 181)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 181
Displaying PoE Status and Settings
Use this procedure to display PoE status and settings at the switch and
port level.
To display PoE information, do the following:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the Power Over Ethernet tab.
Note
The Power Over Ethernet tab appears only for AT-8524POE switches.
The fields in the window are defined here:
Power Threshold
A percentage of the total PoE power on the switch which, when
exceeded, causes the switch to enter an event in the event log and
send an SNMP trap to the management workstations. As an
example, at the default setting of 95%, the threshold is exceeded
whenever the total power requirements of the powered devices
exceed 380 W, which is 95% of 400 W, the maximum total PoE on
an AT-8524POE switch.
Maximum Available
The maximum amount of PoE available from the switch for the
powered devices connected to its ports. This value is 400W for the
AT-8524POE switch.
To view the PoE settings of the individual ports, click a port in the
the graphic switch image and click View. You can select more
than one port at a time.
The columns in the window are defined here:
Port
Port number.
PoE Function
Whether PoE is enabled or disabled on the port. The default
setting is enabled.
Power Consumed
The amount of power in milliwatts currently consumed by the
powered device connected to the port. If the port is not
connected to a powered device, this value will be 0 (zero).