Allied Telesis AT-S62 - Manual (Page 317)

AT-S62 Web Browser Interface User’s Guide
Section VII: Management Security 317
Configuring the SSH Server
This section describes how to configure the SSH server software on the
switch. For an overview of all the steps to configuring the SSH server,
refer to the AT-S62 Menus Interface User’s Guide.
This procedure assumes that you have already created the two key pairs.
You cannot create encryption keys from a web browser management
session.
Prior to configuring the SSH feature, you must disable the SSH server.
When you have completed your configuration changes, enable the SSH
server to permit SSH client connections.
Note
Allied Telesyn recommends disabling the Telnet server before
activating SSH. For instructions, refer to the AT-S62 Menus Interface
User’s Guide. (The Telnet server cannot be disabled from the web
browser interface.)
To configure the SSH server software on the switch, perform the
following procedure:
1. From the Home Page, select Configuration.
2. Select the Mgmt. Protocols menu selection.
3. Select the Secure Shell tab.
The Secure Shell tab is shown in Figure 115.
Figure 115 Secure Shell Tab (Configuration)