Allied Telesis AT-S62 - Manual (Page 224)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 224
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
❑ Creating a Target Address Table Entry on page 218
❑ Deleting a Target Address Table Entry on page 221
❑ Modifying Target Address Table Entry on page 222
For reference information about the SNMPv3 Target Parameters Table,
see Configuring the SNMPv3 Target Parameters Table on page 224.
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 77.
Figure 77 SNMPv3 Target Parameters Table Page