Allied Telesis AT-S62 - Manual (Page 200)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 200
7. In the View Type field, enter one of the following view types:
Included
Enter this value to permit the View Name to see the subtree
specified above.
Excluded
Enter this value to not permit the View Name to see the subtree
specified above.
8. In the Storage Type field, enter a storage type for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Parameters Table to the configuration file.
After making changes to an Target Parameters Table entry with a
Volatile storage type, the Save Config menu selection does not
appear.
NonVolatile
Select this storage type if you want the ability to save an entry in
the View Table to the configuration file. After making changes to
a View Table entry with a NonVolatile storage type, the Save
Config menu selection appears.
Note
The Row Status parameter is a read-only field in the web interface.
The Active value indicates the SNMPv3 View Table entry takes effect
immediately.
9. Click Apply to update the SNMPv3 View Table.
10. To save your changes, select the Save Config menu selection.