Allied Telesis AT-S62 - Manual (Page 148)

Chapter 14: Quality of Service
Section II: Advanced Operations 148
If you specify a new user priority value here and in Flow Group, the
value in Flow Group overwrites the value here.
Flow Group List
The flow groups assigned to this traffic class. Use click to
select more than one.
6. After you have configured the necessary parameters, click Apply.
The new traffic class is created on the switch.
7. To permanently save your changes, select the Save Config menu
selection.
Modifying a
Traffic Class
This procedure explains how to modify an existing traffic class. If the
traffic class you want to modify is already part of a QoS policy assigned
to one or more switch ports, you must first modify the policy by
removing the port assignments before you can modify the traffic class.
You can reassign the ports back to the policy after you have finished
modifying the traffic class.
To modify a traffic class, perform the following procedure:
1. From the home page, select Configuration.
2. Select the Services menu selection.
3. Select the Traffic Class tab.
The Traffic Class tab is shown in Figure 43 on page 144
4. Select the traffic class you want to modify and click Modify.