Allied Telesis AT-S62 - Manual (Page 32)

Chapter 3: Basic Switch Parameters
Section I: Basic Operations 32
Configuring an IP Address and Switch Name
Note
For guidelines on when to assign an IP address, subnet address, and
gateway address to an AT-8500 Series switch, refer to the AT-S62
Menus Interface User’s Guide.
To set basic switch parameters for an AT-8500 Series switch, perform the
following procedure:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the General tab.
The General tab is shown in Figure 7.
Figure 7 General Tab